Flowline

The general purpose loop powered level indicator displays engineering units connected in series with one 4-20 mA continuous level transmitter, and is available with two optional relays and an isolated 4-20 mA repeater. Select this panel mount indicator for use with general purpose two-wire level transmitters. 

LCD main display with secondary unit and bar graph display. Easy configuration via the push button display module. Available with two solid-state, latching relays and an isolated 4-20 mA repeater

Compatible with any EchoPod sensors, the general purpose level indicator displays the measured value, applicable relay status and set point configuration of the attached sensor, as the sensor was configured to operate by WebCal software. PodView requires no programming, and receives both power and data from the connected sensor. Through the indicator, users can adjust EchoPod relay set points in the field. PodView is installed up to 15’ (4.5m) away from the sensor in a panel or NEMA enclosure.

Field mount indicator for use with EchoPod sensors. Indicates level or volume and EchoPod relay status.

The general purpose ultrasonic transmitter provides continuous level measurement up to 49.2” (1.25m) with a 4-20 mA signal output, and is configured via our free WebCal® software. This non-contact liquid level sensor is ideally suited for corrosive, sticky or waste liquids, and is selected for chemical feed, IBC or drum, skid or machine and cooling tower applications.

• Narrow 2” beam width and short 2” dead band optimized for small tanks

The general purpose ultrasonic transmitter provides continuous level measurement up to 49.2” (1.25m) with a 4-20 mA signal output and four relays, and is configured via our free WebCal® software. Each relay is fully configurable for automatic fill, empty or alarm functions, and the embedded level controller may lower cost by replacing external control hardware. This non-contact liquid level sensor is well suited for corrosive, sticky or waste liquids, and is selected for chemical feed, IBC or drum, skid or machine and cooling tower applications.

• Four (4) programmable relays rated @ 1A / 60VA for switch, pump or valve control and fail-safety

The general purpose ultrasonic transmitter provides continuous level measurement up to 9.8’ (3m) with a 4-20 mA signal output and four relays, and is configured via our free WebCal® software. Each relay is fully configurable for automatic fill, empty or alarm functions, and the embedded level controller may lower cost by replacing external control hardware. This non-contact liquid level sensor is well suited for corrosive, sticky or waste liquids, and is selected for IBC or drum, cooling tower, day tank, skid or machine, open channel and chemical feed applications.

• Four programmable relays for switch, pump or valve control and fail-safety