Valves & Actuation
Hayward Angle Valves are used in tight spaces where a 90° change in flow direction is needed and there is insufficient room for extra fittings. Since they are globe type valves, they are ideal for sampling and for throttling applications. Hayward Angle Valves use precision-machined, fine-pitch threaded stems that allow for precise flow control down to shutoff. The 1/4" size valve has integrally molded-in lugs for easy panel mounting of the valve. Pressure Rating - 150 psi @ 70°F (non-shock). Molded-in Lugs for Panel Mounting - 1/4” size. NSF Approved, All PVC Construction.
Operating parameters - for optimum performance, inlet pressure must not exceed 120 psi. Flow rate should not exceed 5 feet per second.
Operating parameters - for optimum performance, inlet pressure must not exceed 120 psi. Flow rate should not exceed 5 feet per second.
Hayward True Union Ball Valves are superior performers. A fine-pitch seal retainer thread allows for accurate compensation for seat wear. Reversible seats make it easy to get a damaged valve back in service. Should the seats become damaged, they only need to be removed, turned over, and re-installed to put the valve back on line. These valves feature a double o ring stem seal for twice the leakage protection of valves with only a single stem seal. Hayward’s manual True Union Ball Valve has been designed so that it can easily be converted to an automated valve in the field. To do this, just remove the compression fit handle and install an actuator mounting bracket.
Hayward True Union Ball Valves are superior performers. A fine-pitch seal retainer thread allows for accurate compensation for seat wear. Reversible seats make it easy to get a damaged valve back in service. Should the seats become damaged, they only need to be removed, turned over, and re-installed to put the valve back on line. These valves feature a double o ring stem seal for twice the leakage protection of valves with only a single stem seal. Hayward’s manual True Union Ball Valve has been designed so that it can easily be converted to an automated valve in the field. To do this, just remove the compression fit handle and install an actuator mounting bracket.